Yealink VC800 - Page 125

Configuring Call Preferences
111
Parameter
Description
Configuration Method
system. You can make point-to-point
calls using
H.323 names if both system are
registered to a gatekeeper.
Default: blank
H.323 Extension
Specifies the extension that
gatekeepers and gateways use to
identify this system.
Default: blank
Note: Users can place point-to-point
calls using the extension if both
systems are registered with a
gatekeeper.
Remote Control
Web User Interface
Gatekeeper
Type/Gatekeeper
Mode
Configures the gatekeeper mode.
 Disabled—the system does not
use a gatekeeper.
 Auto—the system automatically
discovers a gatekeeper.
 Manual—specify the IP address
and port for the gatekeeper
manually.
Default: Disabled
Remote Control
Web User Interface
Gatekeeper
Server1/Gatekeeper
IP Address 1
Configures the IP address of the
primary gatekeeper.
Remote Control
Web User Interface
Gatekeeper Port
1/Port
Configures the port of the primary
gatekeeper.
Valid values: Integer from 0 to
65535.
Default: 1719
Remote Control
Web User Interface
Gatekeeper
Server2/Gatekeeper
IP Address 2
Configures the IP address of the
secondary gatekeeper.
Note: If communication with the
primary gatekeeper is lost, the
system registers with the alternate
gatekeeper.
Remote Control
Web User Interface
Gatekeeper Port
Configures the port of the primary
Remote Control