Administrator’s Guide for Yealink VC800 Video Conferencing System
200
2. Select the desired value from the pull-down list of USB Enable.
3. Click Confirm to accept the change.
A dialog box pops up to prompt that settings will take effect after a reboot.
4. Click Confirm to reboot the system immediately.
Video Recording
Before recording video, make sure a USB flash driver is connected to VC800 codec, VCH50 video
conferencing hub or CP960 conference phone and the USB feature is enabled. For more
information, please refer to USB Configuration on page 199.
The recorded video will be saved in .mkv format and named as the recorded time and date.
Video can be played on either the system itself or on a computer using an application capable of
playing .wav files.
The video recording parameters on the system are described below.
Enables or disables the video
recording feature on the system.
Default: Enabled
If it is set to Disabled, you cannot
record video.
Enables or disables the system to
start recording automatically once a
call is established.
Default: Disabled.
Note: The auto recording feature is
To Next Page
Loading...
