Administrator’s Guide for Yealink VC800 Video Conferencing System
44
4. Select the desired value (0-7) from the pull-down list of Priority.
5. Click Confirm to accept the change.
A dialog box pops up to prompt that the settings will take effect after a reboot.
6. Click OK to reboot the phone.
To configure VLAN via the remote control:
1. Select More->Setting->Advanced (default password: 0000) ->Advanced Network.
2. In the VLAN block, check the Active checkbox.
3. Enter the VLAN ID in the VID(1-4094) field.
4. Enter the priority value (0-7) in the Priority field.
5. Select Save, and then press to accept the change.
The display device prompts “Reboot now?”.
6. Select OK, and then press to reboot the system immediately.
DHCP VLAN
The system supports VLAN discovery via DHCP. When the VLAN Discovery method is set to
DHCP, the system will examine the DHCP option for a valid VLAN ID. The predefined option 132
is used to supply the VLAN ID by default. You can customize the DHCP option used to request
the VLAN ID.
Parameters of VLAN feature on the system are described below.
Enables or disables the DHCP VLAN
discovery feature on the system.
Default: Enabled
Note: If you change this parameter,
the system will reboot to make the
To Next Page
Loading...
