Configuring Network
45
Configures the DHCP option from
which the system obtains the VLAN
settings.
You can configure at most five
DHCP options and separate them by
commas.
Valid Values: 128-254
Default: 132
Note: If you change this parameter,
the system will reboot to make the
change take effect.
To configure DHCP VLAN discovery via web user interface:
1. Click on Network->Advanced.
2. In the VLAN block, select the desired value from the pull-down list of DHCP VLAN Active.
3. Enter the desired option in the Option field.
The default option is 132.
4. Click Confirm to accept the change.
A dialog box pops up to prompt that the settings will take effect after a reboot.
5. Click Confirm to reboot the system immediately.
To Next Page
Loading...
