Yealink VC800 - Page 57

Configuring Network
43
Parameters of manual VLAN on the system are described below.
Parameter
Description
Configuration Method
Internet
Port->Active
Enables or disables VLAN for the
Internet (WAN) port.
Default: Disabled
Note: If you change this parameter,
the system will reboot to make the
change take effect.
Remote Control
Web User Interface
VID(1-4094)
Specifies the identification of the
Virtual LAN.
Default: 1
Note: If you change this parameter,
the system will reboot to make the
change take effect.
Remote Control
Web User Interface
Priority
Configures VLAN priority for the
Internet (WAN) port.
Valid values: 0-7
7 is the highest priority, 0 is the
lowest priority.
Default: 0
Note: If you change this parameter,
the system will reboot to make the
change take effect.
Remote Control
Web User Interface
To configure VLAN for Internet port via web user interface:
1. Click on Network->Advanced.
2. In the VLAN block, select the desired value from the pull-down list of Internet Port
Active.
3. Enter the VLAN ID in the VID (1-4094) field.