Administrator’s Guide for Yealink VC800 Video Conferencing System
124
The call protocol parameter on the system is described below:
Specifies the desired call protocol
for placing calls.
Auto—the system
automatically uses the
available call protocol.
SIP—the system uses the SIP
protocol for placing calls.
H.323—the system uses H.323
protocol for placing calls.
Default: Auto
Remote Control
Web User Interface
To configure call protocol via web user interface:
1. Click on Setting->Call Features.
2. Select the desired value from the pull-down list of Call Protocol.
3. Click Confirm to accept the change.
To configure call protocol via the remote control:
1. Select More->Setting->Call Features->Call Protocol.
2. Select the desired value from the pull-down list of Call Protocol.
3. Select Save, and then press to accept the change.
To Next Page
Loading...
