Administrator’s Guide for Yealink VC800 Video Conferencing System
168
The automatic sleep time is described below:
Configures the inactive time (in
minutes) before the system enter
sleep mode.
Default: 10 Min
Note: During setup wizard, the
automatic sleep time feature is
disabled automatically. To protect
the display device, you should
configure the automatic sleep time
immediately.
Remote Control
Web User Interface
To configure the automatic sleep time via web user interface:
1. Click on Setting->General.
2. Select desired value from the pull-down list of Automatic Sleep Time.
3. Click Confirm to accept the change.
To configure the automatic sleep time via the remote control:
1. Select More->Setting->Basic->Automatic Sleep Time.
2. Select desired value.
3. Select Save, and then press to accept the change.
To Next Page
Loading...
