Yealink VC800 - Page 197

Configuring System Settings
183
to call. If the far site does not support the protocol for sharing content, MCU will automatically
mix the content and camera video, and send them in one channel. For more information on mix
sending, refer to Mix Sending on page 187.
Dual-stream protocol parameters on the system are described below.
Parameter
Description
Configuration Method
H.239
Enables or disables the H.239 protocol for
sharing content. You can configure it for the
StarLeaf Cloud platform or H.323 call
separately.
Default: Enabled
Web User Interface
BFCP
Enables or disables the BFCP protocol for
sharing content. You can configure it for
Zoom/Pexip/BlueJeans/Mind/Custom platform,
SIP account or SIP IP call separately.
Default:
For Zoom/Pexip/BlueJeans/Mind/Custom
platform and SIP IP call, the default value is
Enabled.
For SIP account, the default value is Disabled.
Note: You cannot configure it for the
Yealink/StarLeaf Cloud platform.
Web User Interface
To configure H.239 dual-stream protocol for StarLeaf Cloud platform via web user
interface:
1. Click on Account->VC Platform.
2. Select StarLeaf from the pull-down list of Platform Type.