Administrator’s Guide for Yealink VC800 Video Conferencing System
252
The call logs will be deleted.
Passwords will be reset to default.
All system parameters will be reset to default values.
All custom files will be deleted. Such as, certificates, local contacts and registered accounts.
It is not possible to undo a factory reset. But you can export the configuration first, and then you
can re-import the configuration to recovery the system after the reset.
You can reset the system via the reset key on the VC800 codec, remote control or web user
interface.
Note
To reset the system via web user interface:
1. Click on Setting->Upgrade.
2. Click Reset to Factory Setting.
The web user interface prompts the message “Reset to factory?”.
3. Click Confirm to confirm the resetting.
To reset the system via the remote control:
1. Select More->Setting->Advanced (default password: 0000)->Reboot & Reset.
2. Select Reset, and then press .
The display device prompts” Reset to Factory? ”
3. Select OK, and then press .
The system reboots automatically. The system will reset to factory sucessfully after startup.
Reset of the system may take a few minutes. Do not power off until the phone starts up
successfully.
To Next Page
Loading...
