Administrator’s Guide for Yealink VC800 Video Conferencing System
14
2. Locate the HDMI port on the VC800 codec, and connect it to the HDMI port on the display
device with the supplied HDMI cable (Make sure the display device is powered on).
3. Locate the VC Hub/Phone port on the VC800 codec, and connect it to the Codec port on
the VCH50 video conferencing hub using 7.5m Ethernet cable.
4. Do one of the following to share contents:
- Locate the HDMI port on the VCH50 video conferencing hub, and connect it to the
HDMI port on the PC with the supplied HDMI cable. So that you can share contents
during a call.
- Locate the MINI DP port on the VCH50 video conferencing hub, and connect it to the
MINI DP port on the PC with the supplied MINI DP cable. So that you can share
contents during a call.
5. Locate the Audio port on the VCH50 video conferencing hub, and connect it to the
Internet port on the CP960 conference phone.
6. Connect the DC48V port on the VC800 codec to an AC power outlet with the supplied
power adapter and power cord.
Note
Note
If you do not need presentation, you can locate the VC Hub/Phone port on the VC800 codec,
and connect it to the Internet port on the CP960 conference phone using a 7.5m Ethernet cable
The VC800 video conferencing system should be used with Yealink original power adapter
(48V/0.7A) only. The use of the third-party power adapter may cause the damage to the system.
The cable and wire should be replaced at once if its skin is broken.
To Next Page
Loading...
