Configuring Network
37
Auto
Auto means that the switch will negotiate the network speed and duplex mode for the systems
to transmit voice or data over Ethernet. This process entails devices first sharing transmission
capabilities and then selecting the highest performance transmission mode supported by both
systems.
Half-duplex
Half-duplex transmission refers to transmitting voice or data in both directions, but in one
direction at a time; this means one system can send data on the line, but not receive data
simultaneously.
Full-duplex
Full-duplex transmission refers to transmitting voice or data in both directions at the same time;
this means one system can send data on the line while also receiving data.
Parameter of network speed feature on the system is described below:
Specifies the network speed and
duplex mode for the system to use.
Default: Auto
Note: If Auto is selected, the
network speed and duplex mode
will be negotiated by the switch
automatically.
The network speed and duplex
mode you select must be supported
by the switch.
If you change this parameter, the
system will reboot to make the
change take effect.
To configure the network speed via web user interface:
1. Click on Network->Advanced.
To Next Page
Loading...
