Yealink VC800 - Page 55

Configuring Network
41
TLV Type
TLV Name
Description
Asset ID
Assertion identifier of the system.
Parameters of LLDP feature on the system are described below.
Parameter
Description
Configuration Method
LLDP->Active
Enables or disables LLDP feature on
the system.
Default: Enabled
Note: If you change this parameter,
the system will reboot to make the
change take effect.
Remote Control
Web User Interface
Packet
Interval(1-3600s)
Configures the interval (in seconds)
for the system to send LLDP
requests.
Default: 60
Note: If you change this parameter,
the system will reboot to make the
change take effect.
Remote Control
Web User Interface
To configure LLDP via web user interface:
1. Click on Network->Advanced.
2. In the LLDP block, select the desired value from the pull-down list of Active.