Yealink VC800 - Customizing the VC800 Video Conferencing System; General Settings

Configuring Network
47
Parameter
Description
Configuration Method
CA Certificates
Configures the access URL of the CA
certificate when the 802.1x
authentication mode is configured
as EAP-TLS, PEAP-MSCHAPV2 or
EAP-TTLS/EAP-MSCHAPV2.
Note: If you change this parameter,
the system will reboot to make the
change take effect.
Web User Interface
Device Certificates
Configures the access URL of the
device certificate when the 802.1x
authentication mode is configured
as EAP-TLS.
Note: If you change this parameter,
the system will reboot to make the
change take effect.
Web User Interface
To configure 802.1X via web user interface:
1. Click on Network->Advanced.
2. In the 802.1x block, select the desired protocol from the pull-down list of Mode 802.1x.
a) If you select EAP-MD5:
1) Enter the user name for authentication in the Identity field.
2) Enter the password for authentication in the MD5 Password field.
b) If you select EAP-TLS:
1) Enter the user name for authentication in the Identity field.
2) Leave the MD5 Password field blank.