Administrator’s Guide for Yealink VC800 Video Conferencing System
56
ports.
Valid values: 1-65535
Default range: 50000-50499
Note: SIP and H.323 calls share the
configured ports. If you change this
parameter, the system will reboot to
make the change take effect.
To configure reserved ports via web user interface:
1. Click on Network->NAT/Firewall.
2. In the Reserve Port block, configure the UDP port range in the UDP Port Scope field.
3. In the Reserve Port block, configure the TCP port range in the TCP Port Scope field.
4. Click Confirm to accept the change.
A dialog box pops up to prompt that the settings will be implemented after a reboot.
5. Click Confirm to reboot the system immediately.
To configure reserved ports via the remote control:
1. Select More->Setting->Advanced (default password: 0000) ->NAT/Firewall.
2. In the Reserved block, configure the range of the UDP ports and TCP ports.
3. Select Save, and then press to accept the change.
The display device prompts “Reboot now?”.
To Next Page
Loading...
