BROADSOFT PARTNER CONFIGURATION GUIDE – YEALINK W60B IP DECT PHONE 20-BD5561-00
©
2018 BROADSOFT INC. PAGE 111 OF 117
#Configure the static IP address, submask, gateway and DNS server.
#Require reboot;
static.network.internet_port.ip =
static.network.internet_port.mask =
static.network.internet_port.gateway =
static.network.primary_dns= %DNS_SERVER_1%
static.network.secondary_dns = %DNS_SERVER_2%
static.network.ip_address_mode =
static.network.ipv6_static_dns_enable =
static.network.ipv6_prefix =
static.network.ipv6_primary_dns =
static.network.ipv6_secondary_dns =
static.network.ipv6_internet_port.type =
static.network.ipv6_internet_port.ip =
static.network.ipv6_internet_port.gateway =
##########################################################################
#############
## Time Settings
##
##########################################################################
#############
#Configure the time zone and time zone name. The time zone ranges from -11
to +12, the default value is +8.
#The default time zone name is China(Beijing).
#local_time.time_zone = +8
#local_time.time_zone_name = China(Beijing)
local_time.time_zone = %BWTIMEZONE-1%
local_time.time_zone_name = %TIMEZONENAME%
#Configure the domain name or the IP address of the NTP server. The
default value is cn.pool.ntp.org.
local_time.ntp_server1 = %SNTP_SERVER_1%
local_time.ntp_server2 = %SNTP_SERVER_2%
#Configure the update interval (in seconds) when using the NTP server. The
default value is 1000.
local_time.interval =
#Configure the daylight saving time feature; 0-Disabled, 1-Enabled, 2-
Automatic (default);
local_time.summer_time =
#Configure the DST type when the DST feature is enabled; 0-By Date
(default), 1-By Week;
local_time.dst_time_type =
#Configure the start time of DST. The default value is 1/1/0.
#If the DST type is configured as By Date, the value format is
Month/Day/Hour. For example, the value 5/20/10 means the start time is at
10:00 on May 20.
#If the DST type is configured as By Week, the value format is Month/Day
of Week/Day of Week Last in Month/Hour of Day.
#For example, the value 1/4/2/5 means the start time is at 5 o'clock on
Tuesday of the 4th week in January.
local_time.start_time =
#Configure the end time of DST. The default value is 12/31/23. The value
format is the same to the start time.
local_time.end_time =
To Next Page
Loading...
Need help?
General
