MyPBX Standard User Manual
www.yeastar.com Page 105
The numbers could be set for alert notification, users can setup multiple
extension and outbound phone numbers. Please separate them by „;‟.
e.g. „500;9911‟, if the extension has configured Follow Me Settings, the call
would go to the forwarded number directly.
·Attmtpts
The attempts to dial a phone number when there is no answer.
·Interval
The interval between each attempt to dial the phone number. Must be greater
than 3 seconds, the default value is 10 seconds.
·Prompt
Users will hear the prompt while receiving the phone notification.
2）E-mail Notification Settings
Note: Please ensure that all voicemail settings are properly configured on the
System Settings -> Voicemail Settings page before using this feature.
·E-mail Notification
Whether enable E-mail Notification
·Recipient’ Name
The recipients for the alert notification, and multiple email addresses are
allowed, please separate them by „;‟.
e.g. 123@163.com; 456@sina.com .
·Subject
The subject of the alert email.
·Email Content
Text content support for predefined variables. Variable names and
corresponding instructions are as follows:
$(HOSTNAME) Host name
$(LOCALIP) Local IP address
$(SOURCEIP) Attack source IP address
$(DATETIME) Occurred
$(USERNAME) User name（WEBLOGIN effective）
$(DESTMAC) Attacks destination MAC（IPATTACK effective）
$(DESTPORT) Attacks destination Port number（IPATTACK effective）
$(PROTOCOL) Protocol type（IPATTACK effective）
$(INTERFACE) Network interface name（IPATTACK effective）
To Next Page
Loading...
