MyPBX Standard User Manual
www.yeastar.com Page 85
3.5.13 Callback Settings
MyPBX allows caller A to dial an inbound route number, and after hearing the
ring, A can hang up the call or wait for MyPBX to cut off the call, then MyPBX will
call A with this number. When A pick up the call, A can dial the number he wants
to call; MyPBX will call the number with its outbound route.
Note:
1. If you‟d like to use callback feature, please make sure if it‟s enabled on the
inbound route setting panel.
2. No callback rules needed to be set if the trunk supports call back with the
caller ID directly.
·Allow All Numbers
If you want to apply Callback function to all incoming numbers, please tick Allow
All numbers.
Follow the step to use this function.
Step 1: Enable Callback.
Inbound Routes – Choose “Yes” on” Enable Callback” to enable this function.
Refer to chapter 3.4.5.1
Figure 3.5.13.1
Step 2: Create Callback number
Figure 3.5.13.2
Step 3: Create Callback Rules
You will need to create callback rules when the system should strip or add digits.
To Next Page
Loading...
