MyPBX Standard User Manual
www.yeastar.com Page 62
The number blocked for incoming or outgoing calls or both.
3.5 Internal Settings
3.5.1 Options
1) General
·Ring Timeout
Number of seconds to ring a device before handling the call as per the
extension‟s Follow Me settings . Default value is 30s.
.MAX call duration
The absolute maximum amount of time permitted for a call. A setting of 0
disables the timeout. Default value is 6000s.
.Maximum concurrent calls
Maximum concurrent calls limits. Default value 0 means no limit
·Music on hold
Used to set hold music for the system.
·Tone Region
Please select your country or nearest neighboring country to enable the default
dial tone, busy tone, and ring tone for your region.
Note: please reboot the system to take it effect.
·HTTP bind port/Web Access Port
Port to use for HTTP sessions . Default: 80
Note: please reboot the system to take it effect.
·FXO Mode
FXO port‟s operation mode .
·Enable Follow Me Prompt
When set Follow me to Transfer to number on the extension page (e.g. when
500 is busy, transfer to 501), while 500 is busy, the call will be transferred to
501. If „Enable Follow Me Prompt‟ choosing yes, there will be prompt before
transferring the call. Otherwise, the call will be transferred directly without any
prompt. Default: Yes.
·Virtual Ring Back Tone
It‟s only for GSM trunk. Once enabled, when the caller call out with GSM trunks,
the caller will only hear the virtual ring back tone generated by the system
before callee answers the call.
To Next Page
Loading...
Need help?
General
