To Next Page

To Previous Page

MyPBX Standard User Manual

www.yeastar.com Page 13

2) Voicemail

·Enable Voicemail

Check this box if the user should have a voicemail account.

·Voicemail Access PIN #

Voicemail Password for this extension, i.e. „1234‟ .

3) Mail Setting

·Enable Send Voicemail

Once enabled, the voicemail will be sent to the below email address as an

attachment.

·Send Voicemail to Email Address

This option defines whether or not voicemails/Fax is sent to the Email address

as an attachment.

Note: Please ensure that all voicemail settings are properly configured on the

System Settings -> Voicemail Settings page before using this feature.

4) Flash

·Hook Flash Detection

Sets the amount of time, in milliseconds, that must pass since the last

hook-flash event received by MyPBX before it will recognize a second event. If a

second event occurs in less time than defined by Hook Flash Detection, then

MyPBX will ignore the event. The default value of Flash is 1000 ms, and it can be

configured in 1ms increments.

5) Group

·Pickup Group

If this extension belongs to a pickup group, any calls that ring this extension can

be picked up by other extensions in the same pickup group by dialing the Call

Pickup feature code (default *4).

Note: *4 is the default setting, it can be changed under Feature Codes ->

General -> Call Pickup.

6) Follow me (Call Forwarding)

This function sets inbound call forwarding on an extension. An administrator can

Yeastar Technology MyPBX Standard User Manual

Other manuals for Yeastar Technology MyPBX Standard