MyPBX Standard User Manual
www.yeastar.com Page 18
'Voicemail Settings') have been properly configured before using this feature.
4) Group
·Pickup Group
If this extension belongs to a pickup group, any calls that ring this extension can
be picked up by other extensions in the same pickup group by dialing the Call
Pickup feature code (default is *4).
Note: *4 is the default setting, it can be changed under Feature Codes ->
General -> Call Pickup.
5) Follow me (Call Forwarding)
Call forwarding for an extension can be configured here. The administrator can
configure Follow Me option for this extension. If you want to transfer the call to
an outbound number, please follow the dial pattern of outbound route filled in
the outbound number.
For example: transferring to your mobile phone number 123456789, the dial
pattern of outbound route is „9.‟, you should fill in 9123456789 here.
6）Other Options
.Call Waiting
Check this option if the extension should have Call Waiting capability. If this
option is checked, the „When busy‟ follow me options will not be available. The
call waiting function of IP phone has higher priority than MyPBX‟s call waiting
function.
.DND
Don‟t Disturb. When DND is enabled for an extension, the extension will be not
available.
.User Web Interface
Check this option to allow the user to login to the MyPBX User Web interface,
which can be used to check voicemail and extension recordings. Users may login
to MyPBX User Web interface by using their extension number and voicemail PIN
# as the login and password respectively.
.Ring Out
Check this option if you want to customize the ring time. Ring tone will stop over
the time defined.
7)Spy Settings
MyPBX allows extension to monitor/barge in other conversation. Once this
feature is enabled, the extension has the ability to monitor/barge in other calls
using the feature codes for each spy mode, refer to 'Feature Codes' page for
more information.
To Next Page
Loading...
