MyPBX Standard User Manual
www.yeastar.com Page 78
Figure 3.5.7.1
2) Enable Email to SMS
If you enable this, you can use MyPBX to send out message by sending an email
to the specified address.
·Enable Country Code
If you want to add country code before the dialed numbers, please tick this.
·Country Code
The country code to be add before the dialed numbers.
·Receive mails every
The intervening time of receiving mails from POP3 server.
·Access Code
This PIN code is used to verify the subject of the emails received. If the form of
email passes the verification, it will be send out by SIM card. If not, this email
will be deleted immediately.
3) Email Settings
Note:
1. If you want to use “SMS to Email”, please configure POP3 setting.
2. If you configure the POP3 setting, MyPBX will download emails from the mail
server regularly. Once downloaded, the emails will be deleted from the mail
server.
·Email Address
This email address will be used to:
1. Send email to the addresses listed on “SMS to Email” setting.
To Next Page
Loading...
Need help?
General
