S-Series IP PBX Administrator Guide
49
Calling Party Numbering Type
Select the Calling Party Numbering Type.
Called Party Numbering Plan
Select the Called Party Numbering Plan.
Called Party Numbering Type
Select the Called Party Numbering Type.
The PI provides instructions on whether or not the provided
calling line identity is allowed to be presented, or indicate that
the number is not available.
The SI provides information on the source and the quality of
the provided information.
ISDN/telephony numbering plan (Recommendation E.164)
Dialplan: '(Remote Dialplan:ISDN +) Remote Number Type:
international'.
Dialplan: '(Remote Dialplan:ISDN +)Remote Number
Type:national'.
Dialplan: '(Remote Dialplan:ISDN +)Remote Number
Type:subscriber'.
Dialplan: 'Remote Dialplan:private + Remote Number Type:
subscriber'.
Dialplan: '(Remote Dialplan:ISDN +)Remote Number
Type:unknown'.
Table 5-18 MFC/R2 Trunk Configuration Parameters - Advanced
Dialed Number Identification Service is a telephone service
that enables a company to identify which telephone number
was dialed. Users could configure DNIS to allow the IP
phones to display which trunk is passing the call.
This number is used to identify which line of the trunk is
passing the call.
A name for this DNIS, when a call reaches the selected trunk,
the name will be displayed on the ringing phone.
This option enables or disables forced release of channel. The
default is unchecked.
Most variants of MFC/R2 offer a way to go directly to the call
accepted state, by passing the use of group B and II tones.
This option enables or disables the use of that feature for
incoming calls. The default is unchecked.
Block collect calls with double answer. This will cause that
every answer signal is changed by answer -> clear back ->
answer. The default is unchecked.
Whether or not report to the other end "accept call with
charge".
Specify whether to accept collect calls or not.
To Next Page
Loading...
Need help?
General
