Yeastar Technology S20 Administrator's Guide

S-Series IP PBX Administrator Guide
50
MF Back Timeout
MFC/R2 value in milliseconds for the MF timeout. The default
is None.
Metering Pulse Timeout
MFC/R2 value in milliseconds for the metering pulse timeout.
Enter -1 to use the default value.
DTMF Detection Timeout
Specify the DTMF Detection timeout in milliseconds.The
default is 5000 ms.
Incoming DTMF Mode
Specify the incoming DTMF mode.
First Number of Get
Choose which number to get first.
Outgoing DTMF Mode
Specify the outgoing DTMF mode.
Table 5-19 SS7 Trunk Configuration Parameters - Advanced
SS7 Signaling
Enable DNIS
Dialed Number Identification Service is a telephone service
that enables a company to identify which telephone number
was dialed. Users could configure DNIS to allow the IP
phones to display which trunk is passing the call.
DID Number
This number is used to identify which line of the trunk is
passing the call.
DNIS Name
A name for this DNIS, when a call reaches the selected trunk,
the name will be displayed on the ringing phone.
Start CIC No.
Specify the Circuit Identification Code number of the first B
channel of E1 line (SS7).
Note: the suggested value is the multiples of 32 plus 1, for
example: 1, 33, 65...
Calling Party Number Type
Calling Party Numbering Type
Called Party Number Type
Called Party Number Type
3) DOD
DOD (Direct Outward Dialing) means the caller ID displayed when dialing out. Before configuring
this, please make sure the provider supports this feature.
 Global DOD
Configure Global direct outward dialing number. DOD (Direct Outward Dialing) is the caller
ID displayed when dialing out. Before configuring this, please make sure the carrier supports
this feature.
 Add One DOD with Multiple Extensions
Enter one DOD number and select multiple extensions.

Yeastar Technology S20 Specifications

General

Brand	Yeastar Technology
Model	S20
Category	PBX
Language	English