3-11
IM CW240E
Preparation for Safe Measurements
3
3.2 Connecting a Power Supply
<5> Lock
Lock switch
NiMH battery pack
<3> Remove
<4>
Insert
<3> If using alkaline batteries, raise the lock switch at the back of the CW240 to
remove them from the battery holder. Then install the NiMH battery pack
into the holder.
<4> Place the battery holder into the holder inlet of the CW240. Slide the battery
holder into the slot, so that the battery holder connector connects properly
with the battery connector.
<5> Lower the lock switch on the side of the CW240 to fix the holder.
(The indication changes to "䉭FREE".)
● Recharging the NiMH Battery Pack
When shipped from the factory, the dedicated NiMH battery pack (optional) is
not fully charged for safety reasons.
Recharge the battery pack to its full level before use.
When recharging it, use the CW240 and AC adapter.
WARNING
• When recharging the NiMH battery pack, always do so using the CW240 main
unit.
• When recharging the NiMH battery pack, keep the ambient temperature within
the range from 10°C to 35°C. Recharging the battery pack outside this range
may result in an insufficient amount of charge, solution leakage, or battery
heating.
To Next Page
Loading...
Need help?
General
