5-138
IM 701310-17E
5.22 SSTart Group
:SSTart?
Function Starts the waveform acquisition with the trigger mode
set to single. If the waveform acquisition stops within
the specified time period, 0 is returned at that point.
If not, 1 is returned.
Syntax
:SSTart? {<NRf>}
<NRf> = 1 to 360000 (10 ms resolution: wait period,
START and wait)
0 (START only. No wait.)
–360000 to –1 (10 ms unit: wait time, do
not START and wait)
Example
:SSTART? 100 -> :SSTART 0
Description • If the specified time period is positive, data
acquisition is started in the SINGLE TRIGGER
mode and waits for the operation to stop.
• If the specified time period is 0, data acquisition
is started and 0 is returned without waiting for the
operation to stop.
• If the specified time period is negative, the
instrument simply waits for the operation to stop.
Data acquisition is not started.
To Next Page
Loading...
