YOKOGAWA DL9040

App-3
IM 701310-17E
Appendix
1
2
3
4
5
6
App
Index
Error in Communication Execution (200 to 299)
Code Messages Corrective Action Reference Page
221 Setting conflict. Check the relevant settings. Chapter 5
222 Data out of range. Check the range. Chapter 5
223 Too much data. Check the length of the data. Chapter 5
224 Illegal parameter value. Check the range. Chapter 5
241 Hardware missing. Check the installed options. –
260 Expression error. Equations cannot be used. –
Error in Communication Query (400 to 499)
Code Messages Corrective Action Reference Page
410 Query INTERRUPTED. Check transmission/reception order. 4-2
420 Query UNTERMINATED. Check transmission/reception order. 4-2
430 Query DEADLOCKED. Limit the length of the program message including <PMT> to
1024 bytes or less.
4-2
440 Query UNTERMINATED after indefinite
response.
Do not specify a query after the *IDN? or *OPT? command. –
Error in System Operation (399)
Code Messages Corrective Action Reference Page
399 Fatal error in the communication driver. Maintenance service is required. –
Warning (50)
Code Messages Corrective Action Reference Page
50 *OPC/? exists in message. Place the *OPC or *OPC? command at the end of the
program message.
–
Other Errors (350)
Code Messages Corrective Action Reference Page
350 Queue overflow. Read the error queue. 6-6
Note
Code 350 indicates overflow of error queue. This code is returned as a response to the
STATus:ERRor? query; it does not appear on the screen.
Appendix 2 Error Messages