6-15
IM DLM5058-03EN
Specifications
6
Screen Capture Data Printing and Saving
Item Specifications
Built-in printer (option) Prints screen captures in the specified output format on the built-in printer.
Hardcopy(with Menu): Prints the displayed screen image.
Hardcopy(without Menu): Prints only the waveform area of the displayed screen image.
The menu is not printed. If cursor measurements or automatically
measured results are displayed, they are printed below the
waveform area.
USB printer Prints screen captures on an external USB printer. Color can be turned on or off.
HP inkjet printers are supported.
Network printer Prints screen captures on an external printer via Ethernet.
Color can be turned on or off. HP inkjet and laser printers are supported.
Hardcopy(with Menu): Prints the displayed screen image.
Hardcopy(without Menu): Prints only the waveform area of the displayed screen image.
The menu is not printed. If cursor measurements or automatically
measured results are displayed, they are printed below the
waveform area.
File Saves screen capture data to the specified storage device using one of the following save
modes.
The storage device can be set to internal storage or USB storage.
The output format is PNG, BMP, or JPEG. Available color settings are OFF, ON, ON (Rev),
and ON (Gray).
Hardcopy(with Menu): Saves the displayed screen image.
Hardcopy(without Menu): Saves only the waveform area of the displayed screen image.
The menu is not saved. If cursor measurements or automatically
measured results are displayed, they are printed below the
waveform area.
Wide: Saves a screen capture whose time axis is magnified twice. The
menu is not saved. If cursor measurements or automatically
measured results are displayed, they are printed below the
waveform area.
Saving Data
Item Specifications
Waveform data Saves waveform data (including history waveforms) to the specified storage device.
1
The
saved data can be loaded into the instrument.
Available data formats are binary (.wdf) and ASCII (.csv). Only binary (.wdf) files can be loaded
into the instrument.
Specify the data format, waveform to be saved, history range, window to be saved (Main,
Zoom1, Zoom2), compression mode (OFF, P-P, Decimation).
When loading the data, set the load destination to ACQ memory or Ref1 (Math1) to Ref8
(Math8).
2
If waveform data is loaded into the ACQ memory, the data is cleared when you start waveform
acquisition.
Setup data Saves setup data to the specified storage device.
1
The saved data can be loaded into the
instrument.
Setup data (storage and recall) Up to three sets of setup data can be stored and loaded from the internal memory.
Other types of data The displayed screen image can be saved. Waveform zones can be saved and loaded.
Polygonal zones can be loaded. Snapshot waveforms can be saved and loaded. Automatically
measured waveform parameters can be saved. Serial bus analysis results can be saved. FFT
waveform data can be saved. Histogram data can be saved. History timestamps can be saved.
Symbol data can be loaded.
1 The storage device can be set to internal storage or USB storage.
2 Ref1 (Math1) to Ref4 (Math4) for the DLM5034 and DLM5054
6.5 Features
To Next Page
Loading...
