Common Operations
3-23
IM DLM5058-03EN
3
3.6 Performing Auto Setup
Procedure
Executing Auto Setup
1.
Press AUTO.
Auto setup is executed, and an Undo menu item appears.
Undoing Auto Setup
2.
Press the Undo soft key.
The settings from immediately before the auto setup was executed will be restored.
Explanation
The auto setup feature automatically sets the vertical scale (V/div), time scale (Time/div), trigger
level, and other settings to the most suitable values for the input signals.
Center Position after the Execution of Auto Setup
The center position after you execute auto setup will be 0 V.
Source Channels
CH1 to CH8 (CH1 to CH4 on 4ch models)
Logic waveforms are displayed with the same settings that were used before you executed auto
setup.
Waveforms Displayed before the Execution of Auto Setup
When you perform auto setup, the data in the acquisition memory is overwritten, and the waveforms
that were displayed before you executed auto setup are cleared.
Undoing Auto Setup
You can press the Undo soft key to restore the settings from immediately before the auto setup was
executed. You cannot undo auto setup if you switch to a different setup menu or clear the Undo
menu using the ESC key.
Signals That Auto Setup Can Be Applied To
Frequency: Approx. 50 Hz or higher
Absolute input voltage: Signals whose maximum value is at least approx. 20 mV (at 1:1 setting)
Type: Simple, repeating signals
To Next Page
Loading...
Need help?
General
