AF6ZP0CA – COMBIAC0 & ACE0 2uC – User Manual Page – 63/155
SET OPTIONS
Parameter Allowable range Description
STEERING TYPE
(T, TM)
NONE ÷ ANALOG It allows to select which type of steering unit is connected to
the controller.
NONE = NO steering module is present on the truck,
ACE0/COMBIAC0 does not wait for CAN message by
the EPS and it does not apply EPS and braking steer
cutback.
OPTION#1 = EPS is present and it is configured with
an ENCODER + TOGGLE SWITCHES. These signals
are transmitted to ACE0/COMBIAC0 over CAN bus.
OPTION#2 = EPS is present and it is configured with a
POT + ENCODER. These signals are transmitted to
ACE0/COMBIAC0 over CAN bus.
ANALOG = A hydraulic steer is used on the truck and
ACE0/COMBIAC0 is reading through one of its analog
input the signal coming from a wheel potentiometer in
order to read the wheel rotation.
M.C. FUNCTION
(A)
OFF ÷ OPTION#2 This parameter defines the configuration of the NLC output
(A12), dedicated to the main – or line – contactor.
OFF = Main contactor is not present. Diagnoses are
masked and MC is not driven.
ON = Main contactor is in standalone configuration.
Diagnoses are performed and MC is closed after
key-on only if they have passed.
OPTION#1 = For a traction-and-pump setup, with only
one main contactor for both controllers. Diagnoses are
performed and MC is closed after key-on only if they
have passed.
OPTION#2 = For a traction-and-pump setup, with two
main contactors. Each controller drives its own MC.
Diagnoses are performed and MCs are closed after
key-on only if they have passed.
M.C. OUTPUT
(T, TM, P, CO)
ABSENT, PRESENT This parameter defines whether a load coil is connected to
the NLC output (A12) or not.
ABSENT = NLC output is not connected to any load
coil.
PRESENT = NLC output is connected to a load coil (by
default, that of the main contactor).
EBRAKE ON APPL.
(T, TM, P, CO)
ABSENT, PRESENT This parameter defines whether the application includes an
electromechanical brake or not.
To Next Page
Loading...
Need help?
General
