To Next Page

To Previous Page

Symbologies 13 - 27

Set Lengths for Code 128

Parameter # L1 = D1h, L2 = D2h

The length of a code refers to the number of characters (i.e., human readable characters), including check digit(s)

the code contains. Set lengths for Code 128 to any length, one or two discrete lengths, or lengths within a specific

range.

•

One Discrete Length - Select this option to decode only Code 128 symbols containing a selected length.

Select the length using the numeric bar codes in Appendix D, Numeric Bar Codes. For example, to decode

only Code 128 symbols with 14 characters, scan Code 128 - One Discrete Length, then scan 1 followed by

4. To correct an error or change the selection, scan Cancel on page D-3.

•

Two Discrete Lengths - Select this option to decode only Code 128 symbols containing either of two

selected lengths. Select lengths using the numeric bar codes in Appendix D, Numeric Bar Codes. For

example, to decode only Code 128 symbols containing either 2 or 14 characters, select Code 128 - Two

Discrete Lengths, then scan 0, 2, 1, and then 4. To correct an error or change the selection, scan

Cancel on page D-3.

•

Length Within Range - Select this option to decode a Code 128 symbol with a specific length range.

Select lengths using numeric bar codes in Appendix D, Numeric Bar Codes. For example, to decode

Code 128 symbols containing between 4 and 12 characters, first scan Code 128 - Length Within Range.

Then scan 0, 4, 1, and 2 (enter a leading zero for single digit numbers). To correct an error or change the

selection, scan Cancel on page D-3.

•

Any Length - Select this option to decode Code 128 symbols containing any number of characters within the

digital scanner capability.

NOTE When setting lengths, enter a leading zero for single digit numbers.

Zebra DS4308 Reference Guide

Other manuals for Zebra DS4308