1 - 2 DS3408 Product Reference Guide
•
USB connection to a host. The digital scanner autodetects a USB host and defaults to the HID keyboard
interface type. Select other USB interface types by scanning programming bar code menus.This interface
supports the following international keyboards (for Windows
®
environment): North America, German,
French, French Canadian, Spanish, Italian, Swedish, UK English, Portuguese-Brazilian, and Japanese.
•
Connection to IBM
®
468X/469X hosts. Scan bar code menus to set up communication with the IBM terminal.
•
Wand Emulation connection to a host. The digital scanner connects to a portable data terminal, a controller,
or host which collects the data as wand data and decodes it.
•
Scanner Emulation connection to a host. The digital scanner connects to a portable data terminal / controller
which collects the data and interprets it for the host.
•
Synapse capability which allows connection to a wide variety of host systems using a Synapse and Synapse
adapter cable. The digital scanner autodetects the host.
•
Configuration via 123Scan.
Unpacking
Remove the digital scanner from its packing and inspect it for damage. If the digital scanner was damaged in
transit, contact Zebra Support. See page xvii for contact information. KEEP THE PACKING. It is the approved
shipping container; use this to return the equipment for servicing.
Setting Up the Digital Scanner
Installing the Interface Cable
1. Loosen the two screws on the cable clamp at the bottom of the digital scanner and gently pull the clamp away
from the bottom of the digital scanner.
Figure 1-2
Loosening Screws on Bottom of Digital Scanner
To Next Page
Loading...
Need help?
General
