15 - 8 DS3408 Product Reference Guide
Special Commands
Pause Duration
This parameter, along with Send Pause on page 15-34, inserts a pause in the data transmission. Set the pause by
scanning a two-digit number (i.e., two bar codes), measured in 0.1 second interval in the range of 0.1 to 9.9. For
example, scanning bar codes 0 and 1 in Appendix D, Numeric Bar Codes inserts a 0.1 second pause; 0 and 5
inserts a 0.5 second delay. The default is 1 second. To correct an error or change a selection, scan Cancel on
page D-3.
Pause Duration
Begin New Rule
Scan this bar code to start entering a new rule
.
Begin New Rule
Save Rule
Scan this bar code to save the rule.
Save Rule
To Next Page
Loading...
