Zebra DS4308 Reference Guide

3 - 4 DS3408 Product Reference Guide
Technical Specifications
Digital scanner emits
low/high/low beeps.
Clearing Code 39 buffer. Normal when scanning the Code 39
Buffering
Clear Buffer bar code or
upon attempt to transmit an empty
Code 39 buffer.
Digital scanner emits a power-up
beep after changing USB host
type.
The USB bus re-established power to
the digital scanner.
Normal when changing USB host
type.
Digital scanner emits one high
beep when not in use.
In RS-232 mode, a <BEL> character
was received and Beep on <BEL>
option is enabled.
Normal when
Beep on <BEL> is
enabled and the digital scanner is in
RS-232 mode.
Table 3-1 Troubleshooting (Continued)
Problem Possible Causes Possible Solutions
NOTE If after performing these checks the digital scanner still experiences problems, contact the distributor or
Zebra Support. See page xvii for the telephone numbers.
Table 3-2 Technical Specifications
Item Description
Power Requirements 5 VDC + / - 10% @ approximately 240 mA RMS (nominal), 500 mA (max)
Power Source Depending on host:
• Host powered
• External power supply, 5.2 V nominal
Decode Capability UPC/EAN, UPC/EAN with supplementals, JAN 8 & 13, Bookland EAN, Coupon
Code, Code 128, GS1-128, Code 39, Code 39 Full ASCII, Code 39 Trioptic, Code
32, Code 93, Code 11, Interleaved 2 of 5, Discrete 2 of 5, IATA 2 of 5, Codabar
(NW7), MSI, Inverse 1D, US Postnet, US Planet, UK Postal, Japan Postal,
Australia Postal, Netherlands KIX Code, USPS 4CB/One Code/Intelligent Mail,
UPU FICS Postal, GS1 DataBar, Composite Codes, PDF417, MicroPDF,
Maxicode, Data Matrix (ECC 200), Data Matrix Inverse, QR Code, MicroQR, QR
Inverse, Aztec, Aztec Inverse.
Beeper Operation User-selectable: enable, disable
Beeper Volume User-selectable: three levels
Beeper Tone User-selectable: three tones
Field of View 30º +/- 2º horizontal
22.5º +/- 2º vertical
Yaw Tolerance ± 50° from normal

Zebra DS4308 Specifications

General

Brand	Zebra
Model	DS4308
Category	Barcode Reader
Language	English