Scanning 2 - 3
Macro PDF
2 long low beeps File ID error. A bar code not in the current MPDF sequence was
scanned.
3 long low beeps Out of memory. There is not enough buffer space to store the
current MPDF symbol.
4 long low beeps Bad symbology. Scanned a 1D or 2D bar code in a MPDF
sequence, a duplicate MPDF label, a label in an incorrect order, or
trying to transmit an empty or illegal MPDF field.
5 long low beeps Flushing MPDF buffer.
Fast warble beep Aborting MPDF sequence.
Lo/Hi beeps Flushing an already empty MPDF buffer.
ADF Programming: Normal Data Entry. Duration of tones are short.
Hi/Lo beeps Enter another digit. Add leading zeros to the front if necessary.
Lo/Lo beeps Enter another alphabetic character or scan the
End of Message
bar code.
Hi/Hi beeps Enter another criterion or action, or scan the
Save Rule
bar code.
Hi/Lo/Hi/Lo beeps Rule saved. Rule entry mode exited.
Hi/Lo/Lo beeps All criteria or actions cleared for current rule, continue entering rule.
Low beep Delete last saved rule. The current rule is left intact.
Lo/Hi/Hi beeps All rules are deleted.
ADF Programming: Error Indications. Duration of tones are very long.
Lo/Hi/Lo/Hi beeps Out of rule memory. Erase some existing rules, then try to save rule
again. (It is not necessary to re-enter the current rule.)
Lo/Hi/Lo beeps Cancel rule entry. Rule entry mode exited because of an error or the
user asked to exit rule entry.
Lo/Hi beeps Entry error, wrong bar code scanned. Re-enter criterion or action.
All previously entered criteria and actions are retained. Criteria or
action list is too long for a rule.
Table 2-1
Beeper Definitions (Continued)
Beeper Sequence Indication
To Next Page
Loading...
