Miscellaneous Scanner Options 14 - 9
Synapse Interface
Parameter # F0h, ACh
The auto-detection of a Synapse cable varies in duration depending on the type of Synapse connection. If you
connect a digital scanner to another scanner using a Synapse cable, use the Auxiliary Synapse Port connection. In
all other cases, when using the cable, the default setting is recommended.
To disconnect and reconnect the digital scanner from a Synapse cable that is connected to a live host via a
Synapse, use the "Plug and Play" setting. Do not change this setting from the default if an on-board wedge host is
enabled.
*Standard Synapse Connection
(01h)
Auxiliary Synapse Port Connection
(32h)
“Plug and Play” Synapse Connection
(0Ah)
To Next Page
Loading...
