EasyManuals Logo

ZENEC ZE-MC290 User Manual

ZENEC ZE-MC290
Go to English
124 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #117 background imageLoading...
Page #117 background image
116 117
ENGLISH
116 117
ENGLISH
TROUBLESHOOTING
Problem Cause Corrective action
Unit will not power on.
1. Radio fuse blown. 1. Install new fuse with correct rating.
2. Car battery fuse blown. 2. Install new fuse with correct rating.
3. Illegal operation. 3. Press the [RESET] button located in the
bottom right corner of the front panel.
Remote control does not function.
1. Battery depleted. 1. Replace battery with new one.
2.
Battery installed incorrectly. 2. Remove battery and install correctly.
No/low audio output.
1. Improper audio output connection. 1. Check wiring and correct.
2.
Volume set too low. 2. Increase volume level.
3.
Improper “MUTE” connection. 3. Review wiring diagram and check
“MUTE” connection.
4. Speakers damaged. 4. Replace speakers.
5. Heavily biased balance setting. 5. Adjust the channel balance to the center
position.
6. Speaker wiring is in contact with metal
part of car.
6. Insulate all speaker wiring connections.
Poor sound quality or distortion.
1. Pirated disc is in use. 1. Use original copy.
2.
Speaker power rating not compatible
with unit.
2. Connect proper speakers.
3.
Speaker is shorted. 3. Check speaker contact.
Tel-Mute malfunction.
1. “MUTE” wire is grounded. 1. Check that “MUTE” connection is not
grounded and that it’s properly insulated.
Unit resets itself when engine is off.
1. Incorrect connection between ACC and
positive battery wire.
1. Check wiring and correct.
GENERAL
Problem Cause Corrective action
Monitor does not open
automatically.
1. TFT Auto Open is turned off. 1. Turn TFT Auto Open on.
No image.
1. Incorrect connection to parking brake
wire.
1. Check wiring and correct.
2. PRK SW is activated and parking brake
is not engaged.
2. Stop vehicle in safe place and apply
parking brake.
Flashing image or interference
appears on screen.
1. DVD is not compatible with current TV
system settings.
1. Change setup to accommodate disc.
2. Improper video signal connections. 2. Check wiring and correct.
Prolonged image or improper
height/width ratio display.
1. Improper aspect ratio setup. 1. Use correct aspect ratio setting.
Monitor stops at incorrect position.
1. Moving path is blocked. 1. Press OPEN key to restart monitor
movement.
TFT MONITOR

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ZENEC ZE-MC290 and is the answer not in the manual?

ZENEC ZE-MC290 Specifications

General IconGeneral
BrandZENEC
ModelZE-MC290
CategoryCar Receiver
LanguageEnglish

Related product manuals