ZENEC ZE-MC290 - Monitor Image and Safety Settings

78 79
ENGLISH
78 79
ENGLISH
TFT MONITOR OPERATION
OPEN/CLOSE TFT MONITOR
Press the
[
`
] button on the front panel or press the button on the remote control to
open/close the monitor.
TFT MONITOR AUTO OPEN
■ If “TFT Auto Open” is “on” when the unit is turned on, the monitor automatically moves
to the last viewing position.
■ If “TFT Auto Open” is ”off” when the unit is turned on, press the button on the front
panel or press the button on the remote control to move the monitor into the desired
viewing position.
MONITOR TILT ANGLE ADJUSTMENT
The monitor angle can be adjusted for optimum viewing using one of the following
methods:
■ Press and hold the button to continuously adjust the tilt angle.
■ Release the button while reaching the desired angle.
■ Adjust the “Screen Tilt” in the “Screen setting” to adjust the tilt of the screen to the
desired degree.
REAR CAMERA MODE
■ When the vehicle is put in reverse gear, and an optional rear view camera is connected to
the ZE-MC290, the TFT monitor will automatically switch to the camera input source.
IMAGE SETTING
Video Output Format
■ The table below shows the video output format for each playing source.
Playing source Video output format
FM/AM Tuner RGB mode
DVD RGB mode
DTV RGB mode
NAVI RGB mode
AUX IN CVBS mode
CAMERA CVBS mode
iPOD (Video) CVBS mode
*CVBS – Composite Video Baseband Signal