39
Safety, Installation and Operations Manual – Translation of original instructions
Observe all safety regulations at the installation site. Fence off the working area by appropriate means and wear personal protection equipment.
Make sure that there is sufficient ventilation at the installation site.
The size of the tank in which the pump is installed must be such that:
- any level float switches are able to move freely;
- the number of pump switch on/switch off cycles does not exceed the permitted number ;
Check the electric cable and gaskets for damage and make sure that the impeller turns freely.
Before lifting, make a note of the weight of the product stated on the nameplate and use certified slings, chains and hooks
of suitable load capacity.
Ensure that the electric pump is firmly secured and cannot fall, rotate or swing.
The handle on top is designed to ensure that the pump will be balanced during lifting; however, it may swing when lifted
off the ground
Do not stand close to the pump during handling.
Always wear personal protection equipment.
The ends of the electrical cables are protected with a heat-shrink sheath that stops liquids or humidity from getting in.
This protection does not ensure a water-tight seal and is only able to preserve the cable from water spray or similar (IP44).
Accordingly, do not immerse the ends of the cables in any sort of liquid, not even with the protections on, and only take the sheath off immediately
before setting up the electrical connection to the electric pump.
If the storage location is subject to flooding, be careful to set the ends of the cable up at a higher level than the maximum possible flooding level.
Follow the instructions below to remove the heat-shrink sheath
1. cut across the end of the heat-shrink sheath;
2. make a lengthwise cut in the heat-shrink sheath, taking care not to damage the wires inside;
3. open the flaps of the sheath to expose the wires, and slide the sheath off the cable.
EN
α
4
2 3
5
1
To Next Page
Loading...
