GETTING TO KNOW YOUR TV
HORIZONTAL CONTROL PANEL
The following description applies to models having a
horizontal control paneL
ENIER 4ADJUSTk. SELECT MENU A'_qC)LLtMEv,ACJ..IANNELv ORLON
Front Panel Controls
1. ENTER (ENT)
Press to see the Channel/Audio Mode display, or to
remove any on-screen display or menu.
2. ADJUST (ADJ) Left/Right
Press during on-screen menu operation to see infor-
mation/status display for selected option. Press
again to adjust the selected menu option.
3. SELECT (SEL)
Press during on-screen menu operations to select a
menu option.
4. MENU
Press once to see a menu. Press repeatedly to se-
quence through the available menus.
5. VOLUME (VOL) Up/Down
Press to increase or decrease the sound level.
6. CHANNEL (CH) Up/Down
Press to select channels higher or lower than the chan-
nels being viewed. You can add channels to or delete
channels from the scanning sequence stored in
memory. See CH. ADD/DEL option of the "Setup
Menu" section of this operating guide for channel
programming information.
7. OFF-ON
Press to turn TV power ON or OFF.
8. Remote Control Detector Window
Point the remote control towards this window to
operate the TV.
259_o 4 -- 1
To Next Page
Loading...
