EasyManua.ls Logo

Zenith System 3 - Maintenance and Troubleshooting; TV Care and Protection; Solving Common TV Issues

Zenith System 3
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MAINTENANCE AND TROUBLESHOOTING
CARING FOR YOUR TV
Your TV willlook better, havea longerlife and perform
better if you care for itproperly.
A irstcheck to see that the"IV is off. For added
safety, unplugthe TV from thepower outlet.
Picture Glass Cleaning
The picture tube face attracts dust partides and should be
cleaned regularly. To clean the face, spray a small amount
of glass cleaner on a cleaning cloth and wipe the picture
tube glass face until clean. Repeat if necessary.
To delay new dust accumulation, wet a soft cloth in
lukewarm water in which a little fabric softener or Ivory
dishwashing detergent has been mixed. Wring the cloth al-
most dry. Wipe the glass face. Make sure no drops of mois-
ture are squeezed onto the glass. Do not wipe the glass dry.
Allow the glass to air-dry before you turn the TV on gain.
Cabinet Care
Non-Wood Cabinet orCabinet Components.
Moisten a soft clothwith a mild soap solution orIvory dish-
washingdetergent. Wipe the surfacewith a dampcloth.
Then rinse the cloth in clean water and wipe the surface
gain. Allow the TV to air-drybefore turningit on.
Wood CabinetsorCabinetComponents.
Use any good furniturecleaner and polish. Regularcare
will helppreservethe finish.
EXTENDED ABSENCE
Before an extended absence (such as a vacation) you may
want to unplug the power cord from the electrical wall out-
let. This will protect the TV from possible damage from
lightning or power line surges. If you have an outdoor anten-
na, you may also want to disconnect the antenna lead-in
wires on the back of the TV.
NOTE: If you unplug your "IV, you will have to reset the
clock to the current time.
TV PICTURE INTERFERENCE
Your TV picture may be affected by interference caused by
one or a number of factors. These include:
Nearby Automobile Ignition, Electrical Appliances, etc.
Which causes a speckled, streaked picture. This is most
noticeable in weak signal areas.
Snow tn Picture Caused by insufficient signal. Usually
caused by the TV being located too far from the TV station
or by an improper antenna installation.
Ghosts or Reflections Caused by signals being reflected
from surrounding buildings, water tanks, or other high struc-
tures.
Radio Signal Police, amateur or CB radio transmittersmay
cause interference.
These interference problems can often be corrected
through the use of a better antenna, signal amplifiers, or
various filter devices. See your TV dealer for additional in-
formation, and available TV accessories.
cnc.A_l 11 - 1

Other manuals for Zenith System 3

Related product manuals