Memories
Page 106 Solution & Solution XL Operating Manual – Issue 1.0
Pause Key
Pressing the PAUSE key temporarily halts progression through the memory
stack; the LED in the PAUSE key flashes.
Pressing the PAUSE key again steps backwards through the memory stack
(one memory per key press). The fade times for the current memory are used.
Any wait and delay times defined for the memory are ignored.
Holding down the SHIFT key and pressing the PAUSE key snaps to the
previous memory (ie ignores all timing information).
Pressing the GO key releases the pause; the LED in the PAUSE key goes
out.
Step Key
When the Current memory is a chase with a Manual drive modifier, the STEP
key is used to manually step through the chase.
When the Current memory is a chase with a Beat drive modifier, tapping the
STEP key twice is used to set the speed (beat) of the chase.
To Next Page
Loading...