Macros
Page 136 Solution & Solution XL Operating Manual – Issue 1.0
Running a Macro
A macro can be run using any of the following methods:
Click on the macro in the Macro Window on the monitor.
Use the cursor keys to select the macro in the Macro Window and then
press the ENTER key.
Press the MACRO key to make the MFKs macro selection keys. Use the
PAGE UP or PAGE DOWN keys to select the required page. Press the
macro MFK.
Triggering a memory with an associated macro.
Raising a submaster with an associated macro.
Note – Running Fixture Macros
To run one of the automatic fixture macros (Reset, Lamp On or Lamp
Off) select the fixture(s) first before running the macro as described
above.
Deleting a Macro
Display the Macro window on the monitor. Select a programmed macro to be
deleted.
Press the DELETE key. The Delete Window is displayed on the monitor:
Figure 122 - Deleting a Macro
Select the [OK] button. A confirmation window is displayed. You can then
confirm the deletion or cancel the operation.
To Next Page
Loading...