Zero88 Solution User Manual

Programming
Page 84 Solution & Solution XL Operating Manual – Issue 1.0
Cue Only Option
Cue Only is only applicable in Tracking Mode. The Cue Only option which is
selectable via the [Cue Only] MFK on Special Page 1 and in the Update
Options Window allows you to program new cues or to make changes to cues
without affecting any subsequent cues in the memory stack.
Imagine a scenario where you have two cues, subtly different (Cue 1 and 2).
In between these, you wish to add a blackout with a solo spot for an added
cue (Cue 1.5). Due to the behaviour of tracking, if you added the solo spot
and blackout into an insert cue 1.5, these changes would track forwards into
Cue 2, messing up the state.
By adding the new state as Cue Only, the desk will automatically add the
required tagging into Cue 2 to stop the changes from tracking forwards from
Cue 1.5.
Home Function
The Home function provides a quick method of setting fixture parameters to
their „home‟ values. The home values are taken from the Edit Fixtures table in
Setup and unless they have been specifically edited they will typically be
brightness (intensity) to full, colour to white, no gobo, no prisms, shutter open,
pan and tilt to mid-position etc.
Parameters that are homed are automatically tagged in the Program Window.
The Home function is available at fixture and attribute level. Select the
fixture(s) to be homed and then perform any of the operations summarised in
this table:
Operation
Notes
Press the HOME key
Complete home of all selected fixtures;
removes all effects.
Hold down the FIXTURES key
and press the HOME key
Homes brightness parameters of selected
fixtures; removes all intensity effects.
Hold down the COLOUR key
and press the HOME key
Homes colour parameters of selected
fixtures; removes all colour effects.
Hold down the BEAMSHAPE
key and press the HOME key
Homes beamshape parameters of selected
fixtures; removes all beamshape effects.
Hold down the POSITION key
and press the HOME key
Homes position parameters of selected
fixtures; removes all position effects.
Hold down the EFFECTS key
and press the HOME key
Removes all effects from the selected
fixtures. This is a good way of stopping all
effects from running.
Note – Homing Fixtures over Time
Holding down the TIME key and pressing the HOME key will fade the
fixture outputs to their home values in the internal fade time. The
internal fade time can be found and adjusted on Special Page 1 of the
MFKs.

Zero88 Solution Specifications

General

Brand	Zero88
Model	Solution
Category	Controller
Language	English