Zero88 Solution - Page 61

Setup
Solution & Solution XL Operating Manual – Issue 1.0 Page 61
Loading User Fixture Types
The desk provides a method for loading fixture types which are not in the
fixture library stored on the desk, ie user fixture types which are stored on a
memory stick. Any fixtures which are not in the library can be made using our
Fixture Tools – see our support website at http://support.zero88.com for full
information and to obtain the free software.
To load a user fixture type file, connect the storage media to a USB port on
the desk. If you are using an external floppy drive, remember to insert the
floppy disk into the drive.
Press the [Files] MFK or select the [Files] button on the Setup Window.
Press the [Load UFT] MFK or select the [Load UFT] button on the monitor.
The Select User Fixture File window is displayed on the monitor:
Figure 48 - Loading a User Fixture
Select the required Source Device. A list of UFT files found on the source
device is displayed in the window.
Select the required file and then select the [OK] button. All the fixture types
contained in the selected UFT file are loaded and added to the fixture library
on the desk. A message is displayed indicating how many fixture types have
been loaded:
Figure 49 - Loaded a User Fixture
Clearing User Fixture Types
The desk provides a method for clearing all the User Fixture Types (UFTs)
which have been loaded onto the desk.
Press the [Files] MFK or select the [Files] button on the Setup Window.
Press the [Clear UFT] MFK or select the [Clear UFT] button on the monitor. A
confirmation window is displayed on the monitor:
Figure 50 - Removing User Fixture Types
Press the [Yes] soft key to clear the UFT‟s on the desk.