Setup
Page 72 Solution & Solution XL Operating Manual – Issue 1.0
Light Converse (http://www.lightconverse.net)
The Light Converse visualiser uses Art-Net to communicate with the desk
software, hence the presence of the visualisation configuration settings in the
Art-Net tab of Network Setup. The rules of Art-Net (above) apply when
configuring a Light Converse setup.
Light Converse integration requires a Zero 88 Light Converse USB dongle.
Once active, the system allows bidirectional control of fixtures, selection and
patching via the Ethernet connection.
Capture (CITP) (http://www.capturesweden.com)
Capture 2005 visualising software communicates with the desk via a protocol
known as CITP. This protocol allows for any standard PC network between
the desk and the visualising PC. The console allows you to configure either a
fixed IP address or one allocated via DHCP. As long as the two devices can
see each other, the system should function correctly.
To Next Page
Loading...