Setup
Page 74 Solution & Solution XL Operating Manual – Issue 1.0
Zero Wire
Zero Wire DMX is a wireless DMX transmission system from Zero 88. The
system can be output directly from the console via the [Network] options in
Setup, and can then be routed via a Wireless Access Point to Zero Wire DMX
boxes which decode the signal to DMX for linking to fixtures and dimmers, etc.
In the Zero Wire setup page there are a host of options, which enable each
DMX Universe on the desk to be routed to an IP address with a unique
Universe number (see below).
Figure 59 - ZeroWire Configuration
For more information, see the Zero Wire DMX user manual, which can be
found on the Zero 88 website.
Note: The new ZeroWire CRMX products do not use Zero Wire
communications protocol – they can be defined to use sACN or Art-Net
as required. This section is for support of the older Zero Wire products
only.
Wings
It is possible to connect Ethernet based playback wings to the Solution &
Solution XL. These wings can then be mapped to expand the front panel
controls of the console.
To Next Page
Loading...