MultiBio700- User Manual
eSSL Pvt. Ltd. Page 27
3.6 Entering a Group No.
During face enrollment, the device automatically allocates a
group No. starting from 1 for every user in sequence. When the
number of users in Group No. 1 reaches the upper limit, the
subsequent users will under Group No. 2 automatically. Up to
100 face images can be enrolled in Group No. 1 and only 50 face
images can be enrolled in other groups. If you use the group No.
allocated by the device, you may skip this section.
1. Press [Group No.] on the [Add User] interface to display the
group No. management interface.
2. On the displayed keyboard interface, enter your group No.
and press [OK].
3. After the group No. is entered, an interface is displayed as shown below. Press
[Save] to save the current information and return to the previous interface. Press [Exit]
to return to the previous interface without saving the current information.
Tip: A valid group No. contains 1 to 24 digits. Please remember your own group No.
To Next Page
Loading...
