Product Manual - ZMORPH i500 back to table of content
>>
16
6. How to use your Zmorph
i500 printer
How to use Zmorph i500
Working with Zmorph i500 starts by preparing a 3D model in a modeling software that supports les in one of
the standard formats .stl, .step or delivering a nished model acquired from external sources.
Then, the model has to be opened in a software dedicated by the manufacturer called “Voxelizer Industry”. It
allows you to prepare gcodes for 3D Printing. It is a unique original application for slicing 3D models into layers,
creating a whole chain of processing 3D les into G-code les and sending them to the device.
After selecting the parameters and generating the G-code le, it should be saved. This le can be delivered to
the device using an USB ash drive or imported to an internal memory using a Ethernet or wi- connection. To
avoid the risk of data transfer interruption, it is recommended to use an USB ash drive.
The product is intended for indoor use only. The device is not protected against moisture. Zmorph i500 is
equipped in air-dust lter and HEPA/Carbon ltration.
Unauthorised uses:
▪ It is forbidden to operate the device near ammable substances.
▪ It is forbidden to install the device outside areas which are dry and free from humidity or dust.
▪ It is forbidden to cover the device with any material during operation.
▪ It is forbidden to install or service the device by unqualied persons.
▪ It is forbidden to interfere with the constructional solutions of the product.
▪ It is forbidden to connect the machine to a faulty power supply system.
▪ It is forbidden to connect the device to the a power outlet without grounding.
▪ It is forbidden to insert hands or any body parts between moving parts.
▪ It is forbidden to touch heated elements during operation.
▪ It is forbidden to use the device without the required protective equipment.
▪ It is forbidden for untrained personnel to operate the device.
▪ It is forbidden to use a damaged device.
To Next Page
Loading...
Need help?
General
