Product Manual - ZMORPH i500 back to table of content
>>
7
Health and safety
▪ Regular updating of the rmware is important to prevent defects and damage. To keep track of the
latest instructions and software updates, it is recommended that you visit the site
zmorph3d.com/support regularly.
▪ Place the unit on a level and clean surface.
▪ The device must be secured against overturning, falling from a height or being knocked down by
people moving in the vicinity.
▪ Zmorph i500 3D Printer generates very high temperatures during operation, and has easily accessible
moving parts. Caution is advised.
▪ When operating the printer, avoid situations that could cause burns or interfere with the proper
functioning of the device.
▪ Due to their size and specicity, Zmorph devices are not intended for use by children under 14 years
of age and persons with reduced manual, motor and psychomotor skills. If the device is operated
by handicapped or elderly people, the Manufacturer recommends using assistance or supervision of
appropriately trained personnel.
▪ Do not leave the device unattended for long periods during operation, check the work progress
regularly.
▪ Periodically check the condition and functionality of the 3D printer to avoid potential malfunctions.
▪ Switch o the device after the work is nished, to reduce the energy consumption.
▪ Regularly check the wear and tear of parts in the machine. The list of spare parts can be found in the
spare parts section.
▪ For assistance with technical problems and any maintenance work, please contact the Technical
support at the following address: support.zmorph3d.com/hc/en-us/requests/new
▪ Keep the unit away from heat sources, ammable materials, equipment emitting radiation, moisture,
running water and other liquids.
▪ Before starting work, ensure that the device is out of reach for children and animals.
▪ Be careful not to drop, hit or shake the device.
▪ This device is not intended to operate in a potentially explosive atmosphere.
2.2 General safety information
To Next Page
Loading...
Need help?
General
