Zmorph i500 User Manual

Product Manual - ZMORPH i500 back to table of content >>
29
Setting up Zmorph i500
9.4 Safety features removal
Open the front door and remove the two fasteners from
inside of the machine.
Once you remove the belt
fasteners go to the SETTINGS
menu located on the HOME
screen.
Then open the UTILITIES menu.

Zmorph i500 Specifications

General

Filament Diameter	1.75 mm
Print Technology	Fused Filament Fabrication (FFF)
Nozzle Diameter	0.4 mm (standard)
Filament Compatibility	PLA, ABS, PETG, TPU, Nylon
Connectivity	USB, Ethernet
Software	Voxelizer
Extruder Type	Single Extruder
Display	Touchscreen
Power Requirements	110-240 V, 50/60 Hz